ADTRAN AOS Version R10.1.0 Command Reference Manual page 2877

Command Reference Guide
vrf <name>
Use the vrf command to associate a specific VPN routing and forwarding (VRF) instance with Border
Gateway Protocol (BGP) configurations and enter the BGP Configuration mode on the nondefault VRF
instance. This command allows you to configure the BGP settings for the specified VRF instance. Use the
no form of this command to remove the association between the named VRF instance and the BGP
configuration.
Syntax Description
<name>
Default Values
By default, BGP configurations are associated with the default (unnamed) VRF instance.
Command History
Release 18.3
Functional Notes
VRF instances must be created first before they can be assigned to BGP configuration. Create the VRF
instance using the command
nondefault VRF instance, you can configure the BGP settings for the VRF instance. For example, to
configure the IPv4 BGP characteristics for the nondefault VRF instance RED1, enter the following
commands:
(config)#vrf RED1 route-distinguisher ip 192.17.250.24:33
(config)#router bgp 100
(config-bgp)#vrf RED1
(config-bgp-vrf)#
For more information about VRF and Multi-VRF BGP configuration, refer to the configuration guides
Configuring IPv4 Multi-VRF in AOS (article number 2156) and Configuring BGP in AOS for Releases
18.03.00/R10.1.0 or Later (article number 3524) available online at https://supportforums.adtran.com.
Usage Examples
The following example creates the VRF instance named RED1 and enters the BGP configuration mode for
the nondefault VRF:
(config)#vrf RED1 route-distinguisher ip 192.17.250.24:33
(config)#router bgp 100
(config-bgp)#vrf RED1
(config-bgp-vrf)#
60000CRG0-35E
Specifies the name of the VRF instance to associate with BGP.
Command was introduced.
vrf <name> route-distinguisher on page
Copyright © 2012 ADTRAN, Inc.
BGP Command Set
1460. Once you have created the
2877