ADTRAN AOS Version R10.1.0 Command Reference Manual page 2917

Command Reference Guide
exit
exit
!
VRF name1
VRF BGP settings (affecting only this vRF)
Neighbor #2 Definition
Neighbor #2 common settings (common to all peering with neighbor #2)
exit
!
Address Family for VRF name1
AF BGP settings (affecting this AF)
Neighbor #2 Reference
Neighbor #2 settings specific to this AF
exit
exit
exit
Because the structure of BGP changed with the AOS 18.03.00 release, there are several sections of BGP
configuration commands. The following are the BGP configuration command sections for AOS products,
and are applicable to both the default and nondefault VRF instances:
• BGP Command Set on page 2858
• BGP Neighbor Command Set on page 2878
• BGP Address Family Command Set on page 2895
• BGP AF Neighbor Command Set on page 2916
Once you have enabled BGP in AOS products, you can enter the AF Neighbor Configuration mode by
entering the neighbor command at the BGP AF Configuration mode prompt. To enter the IPv4 BGP AF
Neighbor Configuration mode for the default VRF, enter the command as follows:
>enable
#configure terminal
(config)#router bgp 100
(config-bgp)#address-family ipv4
(config-bgp-ipv4)#neighbor 10.20.1.1
(config-bgp-ipv4-neighbor)#
To enter the IPv6 BGP AF Neighbor Configuration mode for the default VRF, enter the command as
follows:
>enable
#configure terminal
(config)#router bgp 100
(config-bgp)#address-family ipv6
(config-bgp-ipv6)#neighbor 2001:DB8:1::1
(config-bgp-ipv6-neighbor)#
60000CRG0-35E Copyright © 2012 ADTRAN, Inc.
BGP AF Neighbor Command Set
2917