ADTRAN AOS Version R10.1.0 Command Reference Manual page 2799

Command Reference Guide
access-point mac-address <mac address>
Use the access-point mac-address command to specify the medium access control (MAC) address of the
physical wireless access point (AP) Ethernet interface. Use the no form of this command to delete the
MAC address of the AP.
Syntax Description
<mac address>
Default Values
No default values are necessary for this command.
Command History
Release 15.1
Functional Notes
This command binds the wireless access controller (AC) to the AP. Without specifying the MAC address,
the AC cannot control the AP.
Usage Examples
The following example configures an AP MAC address of 00:0A:C8:5F:00:D2:
(config)#interface dot11ap 1
(config-dot11ap 1)#access-point mac-address 00:0A:C8:5F:00:D2
60000CRG0-35E
Specifies a valid 48-bit MAC address. MAC addresses should be expressed
in the following format xx:xx:xx:xx:xx:xx (for example, 00:A0:C8:00:00:01).
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
AP Interface Command Set
2799