ADTRAN AOS Version R10.1.0 Command Reference Manual page 2853

Command Reference Guide
vlan-id <vlan id>
Use the vlan-id command to associate a virtual local area network (VLAN) with the virtual access point
(VAP) interface. Encapsulation 802.1q must be enabled on the access point (AP) before wireless traffic is
routed with the VLAN ID attached. To enable encapsulation, refer to the command
on page 2803. Use the no form of this command to remove an entry.
Syntax Description
<vlan id>
Default Values
By default, the VLAN ID is the same number as the VAP interface number.
Functional Notes
Once encapsulation 802.1q is enabled on the AP, all wireless traffic received on the VAP's service set
identifier (SSID) is mapped to the VLAN (specified by the VLAN ID) when sent out the AP's Ethernet
interface. All wireless traffic received on this VLAN ID at the AP's Ethernet interface is mapped to this
VAP's SSID for wireless transmission.
Command History
Release 15.1
Usage Examples
The following example configures the vlan-id to 4 for VAP interface 1:
(config)#interface dot11ap 1/1.1
(config-dot11ap 1/1.1-bg)#vlan-id 4
60000CRG0-35E
Specifies a VLAN interface ID number. Range is 1 to 4095.
Command was expanded to include the VAP interface.
Copyright © 2012 ADTRAN, Inc.
VAP Interface Command Set
encapsulation 802.1q
2853