ADTRAN AOS Version R10.1.0 Command Reference Manual page 2832

Command Reference Guide
speed
Use the speed command to set the active rate for the radio. Frames cannot be transmitted at a speed that is
higher than the specified active rates. Use the no form of this command to return to the default value.
Variations of this command include the following:
speed best
speed <speed>
Syntax Description
best
<speed>
The speed setting best is recommended.
Default Values
By default, the active rate is set to best.
Command History
Release 15.1
Usage Examples
The following example sets the active rate to best on an 802.11bg wireless radio:
(config)#interface dot11ap 1/1 radio-type 802.11bg
(config-dot11ap 1/1-bg)#speed best
60000CRG0-35E
Sets the transmit speed of the radio to the best available.
Sets the transmit speed of the radio. Available speeds vary based on the
setting in the radio-mode command.
For 802.11a radios, choose from 6, 9, 12, 18, 24, 36, 48, or 54 Mbps.
For 802.11b radios, choose from 1, 2, 5.5, or 11 Mbps.
For 802.11bg radios, choose 1, 2, 5.5, 6, 9, 11, 12, 18, 24, 36, 48, or
54 Mbps.
For 802.11g radios, choose 6, 9, 12, 18, 24, 36, 48, or 54 Mbps.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Radio Interface Command Set
2832