ADTRAN AOS Version R10.1.0 Command Reference Manual page 2904

Command Reference Guide
network <ipv4 address> mask <subnet mask>
Use the network mask command to allow the Border Gateway Protocol (BGP) address family (AF) to
advertise local networks that remote sites should be able to access. This command can be used for an
Internet Protocol version 4 (IPv4) BGP AF on the default or nondefault VPN routing and forwarding
(VRF) instance. Use the no form of this command to remove the configured network.
Syntax Description
<ipv4 address>
<subnet mask>
Default Values
By default, there are no configured BGP networks.
Command History
Release 11.1
Release 18.3
Functional Notes
The network command can be used to specify the advertised routes for BGP AF neighbors on either the
default or nondefault VRF instance. If the behavior is to be created on a nondefault VRF instance, the VRF
instance must first be created using the command
have created the nondefault VRF instance, you can configure the BGP settings for the VRF instance using
the command vrf <name> on page 2877
configure the IPv4 BGP characteristics for the nondefault VRF instance RED1, enter the following
commands:
(config)#vrf RED1 route-distinguisher ip 192.17.250.24:33
(config)#router bgp 100
(config-bgp)#vrf RED1
(config-bgp-vrf)#address-family ipv4
(config-bgp-vrf-ipv4)#
For more information about VRF and Multi-VRF BGP configuration, refer to the configuration guides
Configuring IPv4 Multi-VRF in AOS (article number 2156) and Configuring BGP in AOS for Releases
18.03.00/R10.1.0 or Later (article number 3524) available online at https://supportforums.adtran.com.
60000CRG0-35E
Specifies the network address for the neighbor that AOS will advertise over
BGP. IPv4 addresses should be expressed in dotted decimal notation (for
example, 10.10.10.1).
Specifies the subnet mask that corresponds to a range of IPv4 addresses
(network) or a specific host. Subnet masks must be expressed in dotted
decimal notation (for example, 255.255.255.0).
Command was introduced.
Command was incorporated into Multi-VRF BGP functionality.
vrf <name> route-distinguisher on page
from the router's BGP Configuration mode. For example, to
Copyright © 2012 ADTRAN, Inc.
BGP Address Family Command Set
1460. Once you
2904