Table of Contents
Advertisement
Command Reference Guide
network <ipv6 address/prefix-length>
Use the network command to allow the Border Gateway Protocol (BGP) address family (AF) to advertise
local networks that remote sites should be able to access. This command can be used for an Internet
Protocol version 6 (IPv6) BGP AF on the default or nondefault VPN routing and forwarding (VRF)
instance. Use the no form of this command to remove the configured network.
Syntax Description
<ipv6 address/prefix-length> Specifies the IPv6 address and subnet for the neighbor that AOS will
Default Values
By default, there are no configured BGP networks.
Command History
Release R10.1.0
Functional Notes
The network command can be used to specify the advertised routes for BGP AF neighbors on either the
default or nondefault VRF instance. If the behavior is to be created on a nondefault VRF instance, the VRF
instance must first be created using the command
have created the nondefault VRF instance, you can configure the BGP settings for the VRF instance using
the command
vrf <name> on page 2877
configure the IPv6 BGP characteristics for the nondefault VRF instance RED1, enter the following
commands:
(config)#vrf RED1 route-distinguisher as-4byte 44:356
(config)#router bgp 100
(config-bgp)#vrf RED1
(config-bgp-vrf)#address-family ipv6
(config-bgp-vrf-ipv6)#
For more information about VRF and Multi-VRF BGP configuration, refer to the configuration guides
Configuring IPv4 Multi-VRF in AOS (article number 2156) and Configuring BGP in AOS for Releases
18.03.00/R10.1.0 or Later (article number 3524) available online at https://supportforums.adtran.com.
60000CRG0-35E
advertise over BGP. IPv6 addresses and prefixes should be expressed in
colon hexadecimal format (for example, 2001:DB8:0:3F3B::/64).
Command was introduced.
vrf <name> route-distinguisher on page
from the router's BGP Configuration mode. For example, to
Copyright © 2012 ADTRAN, Inc.
BGP Address Family Command Set
1460. Once you
2906
Advertisement
Table of Contents
