Community List Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
C L
OMMUNITY IST
To activate the Community List Configuration mode, enter the ip community-list command at the Global
Configuration mode prompt. For example:
>enable
#configure terminal
(config)#ip community-list listname
(config-comm-list)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
do on page 71
interface on page 74
All other commands for this command set are described in this section in alphabetical order.
deny on page 2936
permit on page 2937
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

Community List Command Set

2935