ADTRAN AOS Version R10.1.0 Command Reference Manual page 2923

Command Reference Guide
distribute-list
Use the distribute-list command to add route filtering functionality by assigning inbound and outbound
Internet Protocol version 4 (IPv4) and Internet Protocol version 6 (IPv6) access control lists (ACLs) to a
BGP address family (AF) neighbor on either the default or nondefault VPN routing and forwarding (VRF)
instance. Only one inbound/outbound pair of ACLs can be configured for a particular AF neighbor. Use
the no form of this command to disable filtering. Variations of this command include:
distribute-list <ipv4 acl name> in
distribute-list <ipv4 acl name> out
distribute-list <ipv6 acl name> in
distribute-list <ipv6 acl name> out
For a complete list of all extended and standard ACL configuration commands, refer to the
IPv6 Access Control List Command Set on page 3162
Command Set on page
Syntax Description
<ipv4 acl name>
<ipv6 acl name>
in
out
Default Values
By default, distribute-list filtering is disabled.
Command History
Release 12.1
Release 18.3
Release R10.1.0
Functional Notes
The distribute-list command can be used to specify the IPv4 or IPv6 ACL used by a BGP AF neighbor on
either the default or nondefault VRF instance. If the AF neighbor is to be created on a nondefault VRF
instance, the VRF instance must first be created using the command
page 1460. Once you have created the nondefault VRF instance, you can configure the BGP AF neighbor
settings for the VRF instance using the command
Configuration mode. For example, to configure the IPv4 BGP AF neighbor characteristics for the
nondefault VRF instance RED1, enter the following commands:
(config)#vrf RED1 route-distinguisher ip 192.17.250.24:33
(config)#router bgp 100
60000CRG0-35E
3126.
Specifies an IPv4 ACL name. This is a standard IPv4 ACL against which the
contents of the incoming/outgoing routing updates are matched.
Specifies an IPv6 ACL name. This is a standard IPv6 ACL against which the
contents of the incoming/outgoing routing updates are matched.
Applies route filtering to inbound data.
Applies route filtering to outbound data.
Command was introduced.
Command was incorporated into Multi-VRF BGP functionality.
Command was expanded to include IPv6 functionality.
vrf <name> on page 2877
Copyright © 2012 ADTRAN, Inc.
BGP AF Neighbor Command Set
or IPv4 Access Control List
vrf <name> route-distinguisher on
from the router's BGP
2923