ADTRAN AOS Version R10.1.0 Command Reference Manual page 2798

Command Reference Guide AP Interface Command Set
access-point controller-standby
Use the access-point controller-standby command to release wireless access controller (AC) control of
the wireless access point (AP). This command will cause the AC to stop responding to echo requests from
the AP, releasing control of the AP. Use the no form of this command to disable this feature.
Syntax Description
No subcommands.
Default Values
By default, controller-standby mode is disabled.
Command History
Release 15.1 Command was introduced.
Usage Examples
The following example enables controller-standby mode for this AP interface:
(config)#interface dot11ap 1
(config-dot11ap 1)#access-point controller-standby
60000CRG0-35E Copyright © 2012 ADTRAN, Inc. 2798