As Path List Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
AS P L
ATH IST
To activate the Autonomous System (AS) Path List Configuration mode, enter the ip as-path-list
command at the Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#ip as-path-list MyList
(config-as-path-list)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
do on page 71
interface on page 74
All other commands for this command set are described in this section in alphabetical order.
deny <value> on page 2856
permit <value> on page 2857
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

AS Path List Command Set

2855