Vlan Database Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
VLAN D
ATABASE
To activate the Virtual Local Area Network (VLAN) Database Configuration mode, enter the vlan
database command at the Enable security mode prompt. For example:
>enable
#configure terminal
(config)#vlan database
(vlan)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
do on page 71
end on page 72
exit on page 73
interface on page 74
All other commands for this command set are described in this section in alphabetical order.
abort on page 2696
apply on page 2697
reset on page 2698
show on page 2699
vlan <vlan id> on page 2700
vlan <vlan id> media ethernet on page 2701
vlan <vlan id> name <name> on page 2702
vlan <vlan id> state on page 2703
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

VLAN Database Command Set

2695