ADTRAN AOS Version R10.1.0 Command Reference Manual page 2688

Command Reference Guide
tunnel vrf <name>
Use the tunnel vrf command to specify the VPN routing and forwarding (VRF) to use in order to reach the
tunnel source and the tunnel destination. Use the no form of this command to use the default VRF.
VRF on an AOS product allows a single physical router to be partitioned into multiple
virtual routers. Each router instance has its own route table and interface assignments.
Beginning with Release 16.1, all AOS routers supporting multiple VRF instances
(multi-VRF) have an unnamed default VRF instance regardless of whether multi-VRF is
configured. Therefore, executing the abovementioned commands without specifying a VRF
will affect the default unnamed VRF.
Syntax Description
<name>
Default Values
By default, the default VRF is used.
Command History
Release 16.1
Usage Examples
The following example sets the VRF instance to use to reach the tunnel source as VRF RED:
(config)#interface tunnel 1
(config-tunnel 1)#tunnel vrf RED
(config-tunnel 1)#tunnel source 10.10.10.254
(config-tunnel 1)#tunnel destination 10.10.10.1
60000CRG0-35E
Optional. Specifies the name of the VRF.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Tunnel Interface Command Set
2688