ADTRAN AOS Version R10.1.0 Command Reference Manual page 2804

Command Reference Guide AP Interface Command Set
If the control protocol and a VAP share the same VLAN ID, control protocol packets will be intercepted by
the AP while noncontrol protocol packets will be forwarded to the VAP.
If the AP is to be in trunk mode and the AWCP VLAN is not the native VLAN for the trunk, care must be
exercised in transitioning the AP and switchport from access port (nontrunk) mode. The AP should be
configured first, then the switchport set to match. When transitioning the AP, set its AWCP VLAN first, then
enable trunking mode (encapsulation 802.1q). If the AWCP VLAN is the native VLAN on the AP and
switch, AWCP communication will not be lost no matter what combination of trunk mode settings is
applied.
Usage Examples
The following example enables encapsulation 802.1q on this AP and makes VLAN 1 the native VLAN:
(config)#interface dot11ap 1
(config-dot11ap 1)#encapsulation 802.1q awcp-vlan 1 native
60000CRG0-35E Copyright © 2012 ADTRAN, Inc. 2804