ADTRAN AOS Version R10.1.0 Command Reference Manual page 2809

Command Reference Guide
ip address <ipv4 address> <subnet mask>
Use the ip address command to define an Internet Protocol version 4 (IPv4) address for the access point
(AP) Ethernet interface. Use the no form of this command to remove a configured IPv4 address.
Syntax Description
<ipv4 address>
<subnet mask>
Default Values
By default, there are no assigned IPv4 addresses.
Command History
Release 15.1
Functional Notes
The IPv4 address and subnet mask are only needed on the AP interface if the user wants to use remote
authentication dial-in user service (RADIUS) authentication with the wireless clients. A default gateway
may also need to be specified.
Usage Examples
The following example configures an IPv4 address of 192.22.72.101 and a subnet mask of
255.255.255.252:
(config)#interface dot11ap 1
(config-dot11ap 1)#ip address 192.22.72.101 255.255.255.252
60000CRG0-35E
Specifies a valid IPv4 address. IPv4 addresses should be expressed in
dotted decimal notation (for example, 10.10.10.1).
Specifies the subnet mask that corresponds to a range of IPv4 addresses
(network) or a specific host. Subnet masks can be expressed in dotted
decimal notation (for example, 255.255.255.0).
Command was introduced for the AP interface.
Copyright © 2012 ADTRAN, Inc.
AP Interface Command Set
2809