Table of Contents
Advertisement
Command Reference Guide
VLAN Interface Command Set
awcp
Use the awcp command to enable ADTRAN Wireless Control Protocol (AWCP) on this interface. The
AWCP is an ADTRAN proprietary protocol used by an access controller (AC) to communicate with an
access point (AP). Use the no form of this command to disable AWCP for this interface.
Syntax Description
No subcommands.
Default Values
By default, AWCP is enabled on the interface.
Command History
Release 15.1
Command was introduced.
Functional Notes
When the global-level command dot11ap access-point-controller (refer to
dot11ap access-point-control
on page 941
for more information) is enabled, the AWCP function can be disabled on a specific interface
by using the no form of this command from the desired interface. When the global-level command
dot11ap access-point-controller is disabled, it overrides the awcp command setting for the interface.
Usage Examples
The following example disables AWCP on virtual local area network (VLAN) 1:
(config)#interface vlan 1
(config-interface-vlan 1)#no awcp
60000CRG0-35E
Copyright © 2012 ADTRAN, Inc.
2706
Advertisement
Table of Contents
