ADTRAN AOS Version R10.1.0 Command Reference Manual page 2889

Command Reference Guide
remote-as <value>
Use the remote-as command to specify the Border Gateway Protocol (BGP) autonomous system (AS) to
which the neighbor belongs, adding an entry to the BGP neighbor table. This command can be used for
BGP neighbors on either the default or nondefault VPN routing and forwarding (VRF) instance. Use the
no form of this command to return to the default setting.
Syntax Description
<value>
Default Values
By default, no BGP neighbors are defined.
Command History
Release 9.3
Release 18.1
Release 18.3
Functional Notes
The remote-as command can be used to specify the AS number for this BGP neighbor on either the
default or nondefault VRF instance. If the neighbor is to be created on a nondefault VRF instance, the VRF
instance must first be created using the command
have created the nondefault VRF instance, you can configure the BGP neighbor settings for the VRF
instance using the command
example, to configure the BGP neighbor characteristics for the nondefault VRF instance RED1, enter the
following commands:
(config)#vrf RED1 route-distinguisher ip 192.17.250.24:33
(config)#router bgp 100
(config-bgp)#vrf RED1
(config-bgp-vrf)#neighbor 10.20.1.1
(config-bgp-vrf-neighbor)#
For more information about VRF and Multi-VRF BGP configuration, refer to the configuration guides
Configuring IPv4 Multi-VRF in AOS (article number 2156) and Configuring BGP in AOS for Releases
18.03.00/R10.1.0 or Later (article number 3524) available online at https://supportforums.adtran.com.
60000CRG0-35E
Specifies the AS number. This number must be different from the AS
number of the local router (defined using the command
on page 1307). Range is 1 to 4294967295.
Command was introduced.
Command was altered to support 4-byte AS numbers (previously AOS only
supported 2-byte numbers).
Command was incorporated into Multi-VRF BGP functionality.
vrf <name> route-distinguisher on page
vrf <name> on page 2877
Copyright © 2012 ADTRAN, Inc.
BGP Neighbor Command Set
from the router's BGP Configuration mode. For
router bgp <value>
1460. Once you
2889