Table of Contents
Advertisement
Command Reference Guide
Address Family for the default VRF
AF BGP settings (affecting only this AF)
Neighbor #1 Reference
Neighbor #1 AF-specific settings
exit
exit
!
VRF name1
VRF BGP settings (affecting only this vRF)
Neighbor #2 Definition
Neighbor #2 common settings (common to all peering with neighbor #2)
exit
!
Address Family for VRF name1
AF BGP settings (affecting this AF)
Neighbor #2 Reference
Neighbor #2 settings specific to this AF
exit
exit
exit
Because the structure of BGP changed with the AOS 18.03.00 release, there are several sections of BGP
configuration commands. The following are the BGP configuration command sections for AOS products,
and are applicable to both the default and nondefault VRF instances:
•
BGP Command Set on page 2858
•
BGP Neighbor Command Set on page 2878
•
BGP Address Family Command Set on page 2895
•
BGP AF Neighbor Command Set on page 2916
To activate the BGP Neighbor Configuration mode, enter the neighbor command at the BGP
Configuration mode prompt followed by the neighbor's IP address.
The IP address entered in this command must match the address for the interface that the
remote router is using as its update source.
The local router must be able to reach the IP address configured as the neighbor ID. View
the routing table and verify that it includes a route to this address.
60000CRG0-35E
Copyright © 2012 ADTRAN, Inc.
BGP Neighbor Command Set
2879
Advertisement
Table of Contents
