ADTRAN AOS Version R10.1.0 Command Reference Manual page 2943

Command Reference Guide
control
Use the control command to specify source and destination ports. Use the no form of this command to
return to the default setting. Variations of this command include:
control dest-port owamp-control
control dest-port twamp-control
control dest-port <port>
control source-port <port>
Syntax Description
dest-port
owamp-control
twamp-control
<port>
source-port <port>
Default Values
By default, the source port is 0, which means that the source port will be dynamically selected by the
probe. The default destination port is the TWAMP control port, port 862.
Command History
Release 17.2
Release 17.6
Functional Notes
This command can only be executed while in the probe <name> twamp command set.
Usage Examples
The following example specifies a destination control port for the probe1 probe:
(config)#probe probe1 twamp
(config-probe-probe1)#control dest-port owamp-control
60000CRG0-35E
Specifies the type of destination control port.
Specifies the destination One-Way Active Measurement Protocol (OWAMP)
control port (861).
Specifies the destination Two-Way Active Measurement Protocol (TWAMP)
default control port (862).
Specifies a destination TWAMP control port other than the default port 862.
The valid range is 1 to 65535.
Specifies the TWAMP source control port. The valid range is 0 to 65535.
Command was introduced.
Command was expanded to include the twamp-control parameter and
default destination port was set to port 862.
Copyright © 2012 ADTRAN, Inc.
Network Monitor Probe Command Set
2943