Command Reference Guide
association access-list <name>
Use the association access-list command to specify a medium access control (MAC) address filter. This
filter will only allow access to specific wireless clients. A MAC access control list (ACL) must be created
before it can be associated with this wireless access point (AP). Refer to
on page 1254
for more information. Use the no form of this command to remove an associated MAC ACL
from this AP.
Syntax Description
<name>
Default Values
By default, no MAC ACLs are associated with an AP.
Command History
Release 15.1
Usage Examples
The following example configures the AP to use the MAC ACL named allowlist as a filter for allowing
access:
(config)#interface dot11ap 1
(config-dot11ap 1)#association access-list allowlist
60000CRG0-35E
Specifies the name of the previously created MAC ACL.
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
AP Interface Command Set
mac access-list standard <name>
2800