Vlan Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
VLAN C
OMMAND
To activate the Virtual Local Area Network (VLAN) Configuration mode, enter the vlan command at the
Global Configuration mode prompt. For example:
>enable
#configure terminal
(config)#vlan 1
(config-vlan 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
ip flow on page 2691
media ethernet on page 2692
name <name> on page 2693
state on page 2694
60000CRG0-35E
S
ET
Copyright © 2012 ADTRAN, Inc.

VLAN Command Set

2690