Vlan Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
VLAN I
NTERFACE
To create a virtual local area network (VLAN) interface and/or activate the VLAN Interface Configuration
mode, enter the interface vlan command at the Global Configuration mode prompt. For example:
>enable
#configure terminalF
(config)#interface vlan 1
(config-interface-vlan 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
arp arpa on page 2705
awcp on page 2706
bandwidth <value> on page 2707
bridge-group <number> on page 2708
crypto map <name> on page 2709
dynamic-dns on page 2711
ip commands begin on page 2713
ipv6 commands begin on page 2754
mac-address <mac address> on page 2782
max-reserved-bandwidth <value> on page 2783
media-gateway ip on page 2784
packet-capture <name> on page 2785
qos-policy on page 2786
rtp quality-monitoring on page 2788
snmp trap on page 2789
snmp trap link-status on page 2790
traffic-shape rate <value> on page 2791
vrf forwarding <name> on page 2792
vrrp <number> on page 2793
60000CRG0-35E
C S
OMMAND ET
Copyright © 2012 ADTRAN, Inc.

VLAN Interface Command Set

2704