Ap Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
AP I
NTERFACE
The Access Point Interface Configuration command set is used to configure wireless access points (APs)
connecting to an AOS platform running the ADTRAN Wireless Control Protocol (AWCP). The AP is
either a physical standalone unit (such as the NetVanta 150) or integrated within an AOS platform via a
module, also known as an embedded access point module (EAPM).
Enter the interface dot11ap command at the Global Configuration mode prompt to activate the AP
Interface Configuration mode. For example:
>enable
#configure terminal
(config)#interface dot11ap 1
(config-dot11ap 1)#
Additional steps must be performed before the AP is ready for connectivity. The radio-level
settings are configured using the
access point (VAP) settings are configured using the
2837.
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
description <text> on page 70
do on page 71
exit on page 73
interface on page 74
All other commands for this command set are described in this section in alphabetical order.
access-point controller-standby on page 2798
access-point mac-address <mac address> on page 2799
association access-list <name> on page 2800
country-region on page 2801
encapsulation 802.1q on page 2803
ethernet-speed on page 2805
event-history on page 2806
full-duplex on page 2807
half-duplex on page 2808
ip address <ipv4 address> <subnet mask> on page 2809
ip default-gateway <ip address> on page 2810
location <name> on page 2811
name <name> on page 2812
60000CRG0-35E
C S
OMMAND ET
Radio Interface Command Set on page
Copyright © 2012 ADTRAN, Inc.

AP Interface Command Set

2813. The virtual
VAP Interface Command Set on page
2797