ADTRAN AOS Version R10.1.0 Command Reference Manual page 2860

Command Reference Guide
To enable BGP in AOS products, and activate the BGP Configuration mode, enter the router bgp
command at the Global Configuration mode prompt followed by the AS number of the local system of
which this BGP router is a member. To enter the BGP Configuration mode for the default VRF, enter the
command as follows:
>enable
#configure terminal
(config)#router bgp 100
(config-bgp)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
do on page 71
end on page 72
exit on page 73
All other commands for this command set are described in this section in alphabetical order.
address-family on page 2861
bgp on page 2863
bgp default local-preference <value> on page 2865
bgp fast-external-failover on page 2867
bgp log-neighbor-changes on page 2869
bgp router-id <ipv4 address> on page 2871
hold-timer <value> on page 2873
neighbor on page 2875
vrf <name> on page 2877
60000CRG0-35E Copyright © 2012 ADTRAN, Inc.
BGP Command Set
2860