Network Monitor Probe Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
N M
ETWORK ONITOR
This section explains the commands available for Network Monitoring Probes. Probes are software agents
that send test traffic across a network path. Tracks are standalone objects that can help determine the status
of a route based on the success or failure of a probe. The probes can be configured to trigger at particular
intervals. There are five types of probes supported by ADTRAN Operating System (AOS): Internet
Control Message Protocol (ICMP) echo, Transmission Control Protocol (TCP) connect, Hypertext
Transfer Protocol (HTTP) request, Two-Way Active Measurement Protocol (TWAMP), and ICMP
timestamp. Commands common to all the probe types are identified in the following section, as well as
isolated commands that only apply to the specific probe types.
Additional configuration commands are available for associating tracks with each probe. These are
explained in the Network Monitor Track Command Set on page
To activate the Network Monitor Probe Configuration mode, enter the probe command at the Global
Configuration mode prompt followed by the probe name. Specify the probe type of icmp-echo,
tcp-connect, http-request, icmp-timestamp, and twamp. For example:
>enable
#configure terminal
(config)#probe probe1 icmp-echo
(config-probe-probe1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
do on page 71
exit on page 73
interface on page 74
The following commands are applicable to ICMP echo probe types and can be executed after this
command:
(config)#probe <probe name> icmp-echo
data <pattern> on page 2945
destination on page 2946
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 2951
period <value> on page 2953
shutdown on page 2956
size <payload length> on page 2957
source-address <ip address> on page 2958
timeout <value> on page 2962
tolerance on page 2963
60000CRG0-35E
P C
ROBE OMMAND
Copyright © 2012 ADTRAN, Inc.

Network Monitor Probe Command Set

S
ET
2977.
2938