ADTRAN AOS Version R10.1.0 Command Reference Manual page 2803

Command Reference Guide
encapsulation 802.1q
Use the encapsulation 802.1q command to set the wireless access point (AP) for virtual local area
network (VLAN) encapsulation 802.1q mode. This will apply VLAN tags to the user traffic. Use the no
form of this command to disable VLAN encapsulation. Variations of this command include:
encapsulation 802.1q
encapsulation 802.1q awcp-vlan <vlan id> native
encapsulation 802.1q awcp-vlan <vlan id> native priority <level>
Syntax Description
awcp-vlan <vlan id>
native
priority <level>
Default Values
By default, encapsulation 802.1q is disabled on the AP.
Command History
Release 6.1
Release 15.1
Functional Notes
Settings (including encapsulation, VLAN, and native VLAN) for the AP's Ethernet interface must be
coordinated with the physical interface to which the AP is connected.
Since all functions on an AP use the same Ethernet interface, there should be only one VLAN ID set to
native on the entire AP. It is possible that a VLAN can be used on a virtual access point (VAP) and for the
AWCP protocol on the AP's Ethernet, but this is not typical. Typically, the control protocol will use the
native VLAN and the VAP's data will all be tagged on the Ethernet.
This means that one VLAN on one radio's VAP may be set to native or the control protocol (AWCP) VLAN
may be set to native, but not both unless they both use the same VLAN ID. Typically, the control protocol
will use the native VLAN.
60000CRG0-35E
Optional. Specifies an existing VLAN to be used for ADTRAN Wireless
(
Control Protocol AWCP) connection. Valid range is 1 to 4096. For more
information on creating a VLAN, refer to
page 2704.
Enables native mode for the specified VLAN. Packets from this VLAN
leaving the interface will not be tagged with the VLAN number. Any
untagged packets received by the interface are considered a part of the
native VLAN ID. Only one VLAN may be set to native. To change where the
native VLAN resides, the current native must be disabled using the no form
of this command before a new one is set.
Optional. Specifies the 802.1q priority level for AWCP packets generated by
this AP when VLAN tags are applied. Valid range is 1 to 7, with 1 being the
highest priority.
Command was introduced.
Command was expanded to include the access point (AP) interface.
Copyright © 2012 ADTRAN, Inc.
AP Interface Command Set
VLAN Interface Command Set on
2803