ADTRAN AOS Version R10.1.0 Command Reference Manual page 2931

Command Reference Guide
send-community standard
Use the send-community standard command to insert a standard Border Gateway Protocol (BGP)
community attribute to all outgoing route updates for this Internet Protocol version 4 (IPv4) or Internet
Protocol version 6 (IPv6) BGP address family (AF) neighbor. You can insert a BGP community attribute
to the BGP AF neighbor on either the default or nondefault VPN routing and forwarding (VRF) instance.
Use the no form of this command to return to the default setting.
Syntax Description
No subcommands.
Default Values
By default, this command is disabled.
Command History
Release 9.3
Release 18.3
Release R10.1.0
Functional Notes
The send-community standard command can be used to specify the BGP community used by a BGP AF
neighbor on either the default or nondefault VRF instance. If the AF neighbor is to be created on a
nondefault VRF instance, the VRF instance must first be created using the command
route-distinguisher on page
the BGP AF neighbor settings for the VRF instance using the command
router's BGP Configuration mode. For example, to configure the IPv4 BGP AF neighbor characteristics for
the nondefault VRF instance RED1, enter the following commands:
(config)#vrf RED1 route-distinguisher ip 192.17.250.24:33
(config)#router bgp 100
(config-bgp)#vrf RED1
(config-bgp-vrf)#address-family ipv4
(config-bgp-vrf-ipv4)#neighbor 10.20.1.1
(config-bgp-vrf-ipv4-neighbor)#
For more information about VRF and Multi-VRF BGP configuration, refer to the configuration guides
Configuring IPv4 Multi-VRF in AOS (article number 2156) and Configuring BGP in AOS for Releases
18.03.00/R10.1.0 or Later (article number 3524) available online at https://supportforums.adtran.com.
60000CRG0-35E
Command was introduced.
Command was incorporated into Multi-VRF BGP functionality.
Command was expanded to include IPv6 functionality.
1460. Once you have created the nondefault VRF instance, you can configure
Copyright © 2012 ADTRAN, Inc.
BGP AF Neighbor Command Set
vrf <name>
vrf <name> on page 2877 from the
2931