ADTRAN AOS Version R10.1.0 Command Reference Manual page 2833

Command Reference Guide
speed default basic-set
Use the speed default basic-set command to configure the basic rate set for the radio. A client connecting
to the radio must be able to support these rates. Use the no form of this command to return to the default
basic rate set for the radio type. Variations of this command include the following:
speed default basic-set 802.11
speed default basic-set 802.11b
speed default basic-set 802.11g
speed default basic-set ofdm
Syntax Description
802.11
802.11b
802.11g
ofdm
The OFDM basic rate set on an 802.11bg radio should be specified for a network that only
contains 802.11g access points (APs) and clients. This setting maximizes throughput for
802.11g networks, but will not allow 802.11b clients to associate with the access point
(AP).
Default Values
By default, the 802.11bg radio is set to 802.11b and the 802.11a radio is set to ofdm.
Command History
Release 15.1
Usage Examples
The following example sets the basic rate set for 802.11bg (protection mode that supports 802.11b and g
clients) on an 802.11bg wireless radio:
(config)#interface dot11ap 1/1 radio-type 802.11bg
(config-dot11ap 1/1-bg)#speed default basic-set 802.11g
60000CRG0-35E
Speed for 802.11 (1, 2 Mbps).
Speed for 802.11b (1, 2, 5.5, 11 Mbps).
Speed for 802.11bg (protection mode) (1, 2, 5.5, 6, 11, 12, 24 Mbps).
Speed for orthogonal frequency division multiplexing (OFDM) (6, 12,
24 Mbps).
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Radio Interface Command Set
2833