Portal Resource-Name - H3C MSR 20-20 Command Reference Manual

2076 C 135: P
HAPTER ORTAL
Description
Related command:
Example

portal resource-name

Syntax
View
Parameter
Description
Example
C C
ONFIGURATION OMMANDS
all: Specifies all authentication-free rules.
Use the portal free-rule
rule, namely, to specify a source filtering condition or destination filtering
condition.
Use the
undo portal free-rule
rule.
If you specify both the source IP and source MAC address information in a
portal-free rule, the IP address must be a host address with a mask of 32 bits;
otherwise, the specified MAC address will be neglected.
display portal free-rule.
# Configure a portal authentication-free rule where the packets whose source IP
address is 10.10.10.1/24, source interface is Ethernet 1/0, and destination IP
address is any address will not trigger a portal authentication.
<Sysname> system-view
[Sysname] portal free-rule 15 source ip 10.10.10.1 mask 24 interface
ethernet 1/0 destination ip any
portal resource-name resource-name
undo portal resource-name
System view
resource-name: Name of the resource to be protected, a case-sensitive string of 1
to 32 characters.
Use the
portal resource-name
to be protected.
Use the
undo portal resource-name
By default, the name of the resource to be protected is not specified.
n
This command only applies to the devices with portal+ enabled.
# Configure the name of the resource to be protected as portal-info-center.
<Sysname> system-view
[Sysname] portal resource-name portal-info-center
command to configure a portal authentication-free
command to remove the authentication-free
command to configure a name for the resource
command to remove the configuration.