Portal Auth-Network - H3C MSR 20-20 Command Reference Manual

2074 C 135: P
HAPTER ORTAL

portal auth-network

Syntax
View
Parameter
Description
Example
C C
ONFIGURATION OMMANDS
000d-88f8-0eab
Total 1 user(s) matched, 1 listed.
Table 543 Description on the fields of the display portal user command
Field
Index
State
SubState
MAC
IP
Vlan
Interface
Total 1 user(s) matched, 1 listed
portal auth-network network-address { mask-length | mask }
undo portal auth-network { network-address | all }
Interface view
network-address: Authentication subnet address.
mask-length: Length of the subnet mask, in the range of 0 to 32.
mask: Subnet mask, in dotted decimal notation.
all: Specifies all authentication subnets.
Use the
portal auth-network
subnet.
Use the
undo portal auth-network
Note that this command is applicable to only Layer 3 authentication. The portal
authentication subnet for direct authentication is any source IP address, and the
portal authentication subnet for re-DHCP authentication is the one determined by
the private IP address of the interface.
By default, the portal authentication subnet is 0.0.0.0/0, meaning to authenticate
users in all subnets.
# Set the portal authentication subnet to 10.10.10.0/24.
<Sysname> system-view
[Sysname] interface ethernet 1/0
[Sysname-Ethernet1/0] portal auth-network 10.10.10.0 24
2.2.2.2 0
Description
Index of a portal user
Current state of a portal user
Current sub-state of a portal user
MAC address of a portal user
IP address of a portal user
VLAN where a portal user is
Interface to which a portal user is attached
Counts of portal users
command to configure a portal authentication
command to remove the configuration.
Ethernet1/0