Rip Output; Rip Mib-Binding - H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches

2.1.22 rip mib-binding

Syntax
rip mib-binding process-id
undo rip mib-binding
View
System view
Parameters
process-id: RIP process ID, in the range of 1 to 65535.
Description
Use the rip mib-binding command to bind MIB operations with a specified RIP
process.
Use the undo rip mib-binding command to restore the default.
By default, MIB operations are bound to the RIP process with the smallest process ID.
Examples
# Configure RIP 100 to accept SNMP requests.
<Sysname> system-view
[Sysname] rip mib-binding 100
# Restore the default.
[Sysname] undo rip mib-binding

2.1.23 rip output

Syntax
rip output
undo rip output
View
Interface view
Parameters
None
Description
Use the rip output command to enable the interface to send RIP messages.
Chapter 2 RIP Configuration Commands
2-21