Manual Calibration Method - Calibrating Axis 3 - ABB IRB 1200 Product Manual

5.6.5 Manual calibration method - calibrating axis 3

Calibration position of axis 3
The figure shows axis 3 in calibration position.
xx1400001204
Required equipment
Calibration of axis 3 is done by moving the upper arm so that the calibration pin
and calibration stop touches each other gently.
These parts are already fitted to the robot, no extra installation of calibration
equipment is required.
Product manual - IRB 1200
3HAC046983-001 Revision: S
5.6.5 Manual calibration method - calibrating axis 3
© Copyright 2014 - 2021 ABB. All rights reserved.
5 Calibration
Continues on next page
849