ABB IRB 1200 Product Manual page 866

5 Calibration
5.8 Checking the synchronization position
Continued
Using a MoveAbsJ instruction
Use this procedure to create a program that runs all the robot axes to their
synchronization position.
1
2
3
4
5
6
Using the jogging window
Use this procedure to jog the robot to the synchronization position of all axes.
1
2
3
4
5
6
866
Action
Tap Code.
Create a new program.
Use MoveAbsJ in the Add Instruction menu.
Create the following program:
MoveAbsJ [[0,0,0,0,0,0],
[9E9,9E9,9E9,9E9,9E9,9E9]]
\NoEOffs, v1000, fine, tool0
Run the program in manual mode.
Check that the synchronization marks for the axes
align correctly. If they do not, update the revolu-
tion counters.
Action
Tap Jog.
From the Mechanical unit list select a
mechanical unit.
From the Motion mode section, select an
axis-set that need to be jogged.
For example, to jog axis 2, select the axis
set Axis 1-3.
Follow the screen instruction on joystick
movements to understand the direction of
the axis that you want to move and move
the joystick.
Manually run the robots axes to a position
where the axis position value read on the
FlexPendant, is equal to zero.
Check that the synchronization marks for
the axes align correctly. If they do not, up-
date the revolution counters.
© Copyright 2014 - 2021 ABB. All rights reserved.
Note
See Synchronization marks and
synchronization position for axes on
page 810 and Updating revolution
counters on page 813.
Note
See Synchronization marks and synchron-
ization position for axes on page 810
Updating revolution counters on page
Product manual - IRB 1200
3HAC046983-001 Revision: S
and
813.