ABB IRB 1200 Product Manual page 772

4 Repair
4.6.8 Replacing the axis-5 timing belt
Continued
Consumable
Locking liquid
Sealant
Deciding calibration routine
Decide which calibration routine to be used, based on the information in the table.
Depending on which routine is chosen, action might be required prior to beginning
the repair work of the robot, see the table.
1
Removing the timing belt
Use these procedures to remove the axis-5 timing belt.
Preparations before removing the timing belt
1
Continues on next page
772
Action
Decide which calibration routine to use for
calibrating the robot.
• Reference calibration. External cable
packages (DressPack) and tools can
stay fitted on the robot.
• Fine calibration. All external cable
packages (DressPack) and tools
must be removed from the robot.
If the robot is to be calibrated with refer-
ence calibration:
Find previous reference values for the axis
or create new reference values. These val-
ues are to be used after the repair proced-
ure is completed, for calibration of the ro-
bot.
If no previous reference values exist, and
no new reference values can be created,
then reference calibration is not possible.
If the robot is to be calibrated with fine
calibration:
Remove all external cable packages
(DressPack) and tools from the robot.
Action
Decide which calibration routine to use,
and take actions accordingly prior to begin-
ning the repair procedure.
© Copyright 2014 - 2021 ABB. All rights reserved.
Art. no. Note
3HAB7116-1 Loctite 243
For robots with protection class
IP67
For robots with protection type
Foundry Plus
3HAC073510-001 Trans Clear
For robots with protection type
Hygienic
Note
Note
Calibrating axis 6 always requires tools to
be removed from the mounting flange (also
for reference calibration) since the mount-
ing flange is used for installation of the
calibration tool.
Follow the instructions given in the refer-
ence calibration routine on the FlexPendant
to create reference values.
Creating new values requires possibility to
move the robot.
Read more about reference calibration for
Axis Calibration in
routine on page
Note
Reference calibration
819.
Product manual - IRB 1200
3HAC046983-001 Revision: S