Frame-Relay Keepalive - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

frame-relay keepalive

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
frame-relay keepalive [ seconds ]
no frame-relay keepalive
Command introduced before JunosE Release 7.1.0.
Enables the LMI mechanism for serial lines using Frame Relay encapsulation. The no
version disables this capability. The keepalive command is similar to the frame-relay
lmi-t391dte command.
seconds—Number in the range 5–30; default value is 10 seconds; defines the keepalive
interval; the interval must be set, and the value on the DTE should be less than the
value set on the DCE
Interface Configuration
Chapter 7: F Commands
641