Failover-Resync - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

failover-resync

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
failover-resync { failover-protocol | failover-protocol-fallback-to-silent-failover |
silent-failover | disable | not-configured }
no failover-resync
Command introduced in JunosE Release 7.3.0.
Configures the L2TP peer resynchronization method that an L2TP failed endpoint uses
to resynchronize with its peer non-failed endpoint. This command configures peer
resynchronization for a host profile or a domain map tunnel, and overrides a global peer
resynchronization method that is specified in Global Configuration mode. The no version
restores the default setting, not-configured.
failover-protocol—Specifies the L2TP failover protocol method
failover-protocol-fallback-to-silent-failover—Specifies the L2TP failover protocol
method; however, if the peer does not support this method, the silent failover method
is used
silent-failover—Specifies the silent failover method
disable—Disables peer resynchronization
not-configured—Specifies that peer resynchronization is not configured for L2TP host
profiles and AAA domain map tunnels. L2TP uses the global failover method; the
default setting
Domain Map Tunnel Configuration, L2TP Destination Profile Host Configuration
Chapter 7: F Commands
623