Bandwidth - H3C CR16000-F Command Reference Manual

Use undo arp send-rate to remove the ARP packet sending rate limit for a VSI interface.
Syntax
arp send-rate pps
undo arp send-rate
Default
The ARP packet sending rate is not limited for a VSI interface.
Views
VSI interface view
Predefined user roles
network-admin
Parameters
pps : Specifies a rate limit in the range of 1 to 500 pps.
Usage guidelines
VMs have limited capacity to process packets. To prevent packet processing from degrading VM
performance, limit the ARP packet sending rate of the VSI interface for VMs. The VTEP will drop
excess ARP packets if the rate limit is exceeded.
Examples
# Set the ARP packet sending rate limit to 50 pps for VSI-interface 1.
<Sysname> system
[Sysname] interface vsi-interface 1
[Sysname-Vsi-interface1] arp send-rate 50

bandwidth

Use bandwidth to set the expected bandwidth for a VSI interface.
Use undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth
Default
The expected bandwidth (in kbps) of a VSI interface equals the interface baudrate divided by 1000.
Views
VSI interface view
Predefined user roles
network-admin
Parameters
bandwidth-value : Specifies the expected bandwidth in the range of 1 to 400000000 kbps.
Usage guidelines
The expected bandwidth is an informational parameter used only by higher-layer protocols for
calculation. You cannot adjust the actual bandwidth of an interface by using this command.
36