ADTRAN AOS Version R10.1.0 Command Reference Manual page 2620

Command Reference Guide
ip ffe
Use the ip ffe command to enable the RapidRoute Engine on this interface with the default number of
entries. Use the no form of this command to disable this feature. Variations of this command include:
ip ffe
ip ffe max-entries <value>
Issuing this command will cause all RapidRoute entries on this interface to be cleared.
Syntax Description
max-entries <value>
Default Values
By default, the RapidRoute Engine is disabled. The default number of max-entries is 4096.
Command History
Release 13.1
Release 17.6
Functional Notes
RapidRoute can be used to help reduce routing overhead, reducing overall routing times. Routing times
are reduced by the creation of a flow table on the ingress interface. The maximum number of entries that
can be stored in the flow table at any one time may be specified by using the max-entries parameters.
Usage Examples
The following example enables RapidRoute and sets the maximum number of entries in the flow table to
50:
(config)#interface tunnel 1
(config-tunnel 1)#ip ffe max-entries 50
60000CRG0-35E
Optional. Specifies the maximum number of entries stored in the flow table.
Valid range is from 1 to 8192.
Command was introduced.
Command was expanded to include the high level data link control (HDLC)
and tunnel interfaces.
Copyright © 2012 ADTRAN, Inc.
Tunnel Interface Command Set
2620