ADTRAN AOS Version R10.1.0 Command Reference Manual page 2648

Command Reference Guide
ip route-cache
Use the ip route-cache command to enable fast-cache switching on the interface. Use the no form of this
command to disable fast-cache switching and return to process switching mode.
Using network address translation (NAT) or the AOS firewall capabilities on an interface
requires process switching mode (using the no ip route-cache command).
Syntax Description
No subcommands.
Default Values
By default, fast-cache switching is enabled on all Ethernet and virtual Frame Relay subinterfaces. IP route
cache is enabled for all virtual Point-to-Point Protocol (PPP) interfaces.
Command History
Release 9.1
Functional Notes
Fast switching allows an IP interface to provide optimum performance when processing IP traffic.
Usage Examples
The following example enables fast switching on the tunnel interface:
(config)#interface tunnel 1
(config-tunnel 1)#ip route-cache
60000CRG0-35E
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Tunnel Interface Command Set
2648