ADTRAN AOS Version R10.1.0 Command Reference Manual page 2663

Command Reference Guide
ipv6 nd other-config-flag
Use the ipv6 nd other-config-flag command to specify the O flag in Internet Protocol version 6 (IPv6)
router advertisement (RA) messages. This command is only effectual when the interface is in router mode.
When the O flag is set, hosts receiving the RA messages are instructed that they may use stateless Dynamic
Host Configuration Protocol version 6 (DHCPv6) to receive information that is not IPv6 addressing
information, and to use some other method (whether through manual configuration, stateless address
autoconfiguration (SLAAC), etc.) for addressing information. Use the no form of this command to disable
the O flag setting.
Syntax Description
No subcommands.
Default Values
By default, the O flag is not set in RA messages.
Command History
Release 18.1
Release R10.1.0
Functional Notes
If the M flag is set for RA messages, you do not need to set the O flag.
Usage Examples
The following example sets the O flag in RA messages from the interface:
(config)#interface tunnel 1
(config-tunnel 1)#ipv6 nd other-config-flag
60000CRG0-35E
Command was introduced.
Command was expanded to include the tunnel interface.
Copyright © 2012 ADTRAN, Inc.
Tunnel Interface Command Set
2663