ADTRAN AOS Version R10.1.0 Command Reference Manual page 2646

Command Reference Guide
ip rip send version
Use the ip rip send version command to configure the Routing Information Protocol (RIP) version the
unit sends in all RIP packets transmitted on the interface. Use the no form of this command to restore the
default value. Variations of this command include:
ip rip send version 1
ip rip send version 2
Syntax Description
1
2
Default Values
By default, all interfaces transmit RIP version 1 (the default value for the version command).
Command History
Release 9.1
Functional Notes
Use the ip rip send version command to specify a RIP version that overrides the version (in the Router
RIP) configuration. Refer to
AOS only transmits one version (either 1 or 2) on a given interface.
Usage Examples
The following example configures the tunnel interface to transmit only RIP version 2 packets:
(config)#interface tunnel 1
(config-tunnel 1)#ip rip send version 2
60000CRG0-35E
Transmits only RIP version 1 packets on the interface.
Transmits only RIP version 2 packets on the interface.
Command was introduced.
version on page 3035 for more information.
Copyright © 2012 ADTRAN, Inc.
Tunnel Interface Command Set
2646