Ppp Mp Virtual-Template - H3C MSR 20-20 Command Reference Manual

Related command:
Example

ppp mp virtual-template

Syntax
View
Parameter
Description
Example
You can configure the following parameters on the virtual-template:
Local IP address and the IP address (or IP address pool) assigned to the peer
■
PPP working parameter
■
ppp mp and ppp mp max-bind.
# Specify the VT interface that corresponds to user 1 as 1, and configure the IP
address of the VT as 202.38.60.1.
<Sysname> system-view
[Sysname] ppp mp user user1 bind virtual-template 1
[Sysname] interface virtual-template 1
[Sysname-Virtual-Template1] ip address 202.38.60.1 255.255.255.0
ppp mp virtual-template number
undo ppp mp
Interface view
number: Specifies the VT interface number to be bound on the interface, in the
range 0 to 1023.
Use the
ppp mp virtual-template
number to be bound on the interface, enabling the interface to work in MP mode.
Use the
undo ppp mp
the interface to work in PPP mode.
By default, MP binding on the interface is disabled, and the interface works in PPP
mode.
This command specifies the VT interface number to be bound on the interface. In
configuring MP binding on the interface configured with this command, you
needs not configure PAP or CHAP authentication.
Two or more interfaces with the same virtual template number is bound directly
together. Moreover, once you used this command on an interface, you cannot use
the ppp mp command on the same interface, and vice versa.
# Configure interface serial 1/0 encapsulated with PPP to work in MP mode, with
the VT interface being Virtual-Template1
<Sysname> system-view
[Sysname] interface serial 1/0
[Sysname-Serial1/0] ppp mp virtual-template 1
command to configure the VT interface
command to remove MP binding of the interface, making
521