X25 Switch Svc Hunt-Group - H3C MSR 20-20 Command Reference Manual

Example

x25 switch svc hunt-group

Syntax
View
Parameter
Description
# Configure an SVC to forward the packet to the X.121 address 20112451
through interface Serial2/0.
<Sysname> system-view
[Sysname-Serial2/0] x25 switch svc 20112451 interface serial 2/0
# Configure an SVC to forward the packet to the address 3 through the Annex G
DLCI 100 of interface Serial 2/0.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] link-protocol fr
[Sysname-Serial2/0] fr dlci 100
[Sysname-Serial2/0] annexg dce
[Sysname-Serial2/0] quit
[Sysname] x25 switch svc 3 interface serial 2/0 dlci 100
x25 switch svc x.121-address [ sub-dest destination-address | sub-source
source-address ] * hunt-group hunt-group-name
undo x25 switch svc x.121-address [ sub-dest destination-address ] [ sub-source
source-address ] [ hunt-group hunt-group-name ]
System view
x.121-address: Destination X.121 address, a pattern matching string with 1 to 15
numeric characters. For the specific description of pattern matching, see Table 69
and Table 70. If no wildcard is used, the X.121 address is must be exactly matched.
sub-dest destination-address: X.121 address, an alphanumeric string of 1 to 15
characters. The system replaces the destination DTE address in the call request
packet with the destination-address.
sub-source source-address: X.121 address, an alphanumeric string of 1 to 15
characters. The system replaces the source DTE address in the call request packet
with the source-address.
hunt-group hunt-group-name: Specifies a hunt group.
Use the x25 switch svc hunt-group
whose forwarding address is a hunt group.
Use the
undo x25 switch svc hunt-group
X.25 switching SVC.
By default, no X.25 switching SVC is configured.
Note that:
After the X.25 switching SVC with forwarding address being a hunt group is
■
configured, the relevant X.25 call request packet will be forwarded to different
command to add an X.25 switching SVC
command to delete the specified
461