X25 Timer Hold; X25 Timer Idle - H3C MSR 20-20 Command Reference Manual

464 C 26: LAPB
HAPTER
Example

x25 timer hold

Syntax
View
Parameter
Description
Example

x25 timer idle

Syntax
View
Parameter
Description
X.25 C C
AND ONFIGURATION OMMANDS
# Enable X.25 switching function.
<Sysname> system-view
[Sysname] x25 switching
x25 timer hold minutes
undo x25 timer hold
Interface view
minutes: Value of delay time in minutes, in the range 0 to 1000.
Use the x25 timer hold
request to a destination to which a previous request failed to reach.
Use the
undo x25 timer hold
By default, the delay time is 0 second.
Frequently sending call requests to a wrong destination (which does not exist or is
faulty) will deteriorate the operating efficiency of the device. Using this function
can avoid this problem to a certain extent. If the previous call failed at one
destination, the X.25 would not send calls to such a destination again within the
specified time.
If this parameter is set to 0, it is equal to disabling the function. In addition, this
function is only effective to the calls originating from the local. That is to say, this
parameter is meaningless when the X.25 operates in the switching mode.
# Set the delay of the X.25 interface Serial 2/0 to 5 minutes.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 timer hold 5
x25 timer idle minutes
undo x25 timer idle
Interface view
minutes: Maximum idle time of SVC in minutes, ranging from 0 to 255.
Use the
x25 timer idle
the interface.
command to set the delay for sending another calling
command to restore the default.
command to set the maximum idle time of the SVC on