466
C
26: LAPB
HAPTER
Example
x25 timer tx1
Syntax
View
Parameter
Description
Related command:
Example
x25 timer tx2
Syntax
View
Parameter
X.25 C
C
AND
ONFIGURATION
OMMANDS
# Set the restart timer on the X.25 interface Serial 2/0 to 120 seconds.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 timer tx0 120
x25 timer tx1 seconds
undo x25 timer tx1
Interface view
seconds: Time of calling request (indication) sending timer in seconds, ranging
from 0 to 1000.
Use the
x25 timer tx1
for the DTE (or DCE).
Use the
undo x25 timer tx1
By default, the timer time on a DTE is 200 seconds, and that on a DCE is 180
seconds.
According to X.25, a timer should be started when the DTE sends a call request (or
the DCE sends a call indication). If no peer acknowledgement is received after the
timer timeout, the sending end will take some measures to guarantee the normal
proceeding of the local procedure. This parameter specifies the time of this timer.
x25 timer tx0, x25 timer tx2, x25 timer tx3.
# Set calling request (indication) sending timer on the X.25 interface Serial2/0 to
100 seconds.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 timer tx1 100
x25 timer tx2 seconds
undo x25 timer tx2
Interface view
seconds: Reset request (indication) timer in seconds, ranging from 1 to 1000.
command to set calling request (indication) sending timer
command to restore the default.