X25 Timer Tx3 - H3C MSR 20-20 Command Reference Manual

Description
Related command:
Example

x25 timer tx3

Syntax
View
Parameter
Description
Related command:
Example
Use the
x25 timer tx2
DTE (or DCE).
Use the
undo x25 timer tx2
By default, the timer on a DTE is 180 seconds, and that on a DCE is 60 seconds.
According to X.25, a timer should be started when a DTE sends a reset request (or
a DCE sends a reset indication). If no peer acknowledgement is received after the
timer timeout, the sending end will take some measures to guarantee the normal
proceeding of the local procedure.
x25 timer tx0, x25 timer tx1, x25 timer tx3.
# Set the reset timer on the X.25 interface Serial1/0 to 120 seconds.
<Sysname> system-view
[Sysname] interface serial 1/0
[Sysname-Serial1/0] x25 timer tx2 120
x25 timer tx3 seconds
undo x25 timer tx3
Interface view
seconds: Time of the clear request (indication) sending timer in seconds, ranging
from 1 to 1000.
Use the
x25 timer tx3
timer for DTE (or DCE).
Use the
undo x25 timer tx3
By default, the clear timer on a DTE is 180 seconds, and that on a DCE is 60
seconds.
According to X.25, a timer should be started when a DTE sends a clear request (or
a DCE sends a clear indication). If no peer acknowledgement is received after the
timer timeout, the sending end will take some measures to guarantee the normal
proceeding of the local procedure.
x25 timer tx0, x25 timer tx1, x25 timer tx2.
# Set the clear timer on the X.25 interface Serial 2/0 to 100 seconds.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 timer tx3 100
command to set the reset request (indication) timer for
command to restore the default.
command to set the clear request (indication) sending
command to restore the default.
467