X25 Vc-Per-Map; X25 Vc-Range - H3C MSR 20-20 Command Reference Manual

468 C 26: LAPB
HAPTER

x25 vc-per-map

Syntax
View
Parameter
Description
Example

x25 vc-range

Syntax
View
Parameter
X.25 C C
AND ONFIGURATION OMMANDS
x25 vc-per-map count
undo x25 vc-per-map
Interface view
count: Maximum number of VCs, ranging from 1 to 8.
Use the
x25 vc-per-map
connections with the same destination device.
Use the
undo x25 vc-per-map
The default is 1.
If the parameter is greater than 1, and the sending window and the sending
queue of VC are filled full, the system will create a new VC to the same
destination. If the new VC cannot be created, packets will be discarded.
# Set the maximum value of VCs on the X.25 interface Serial 2/0 to 3.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 vc-per-map 3
x25 vc-range { bi-channel ltc htc [ out-channel loc hoc ] | in-channel lic hic
[ bi-channel ltc htc ] [ out-channel loc hoc ] | out-channel loc hoc }
undo x25 vc-range
Interface view
bi-channel ltc htc: Lowest and highest two-way channels of X.25 VC, and its
value ranges from 0 to 4095. If htc (highest two-way channel) is set to 0, ltc
(lowest two-way channel) must also be set to 0, which indicates that the two-way
channel section is disabled.
out-channel lic hic: Lowest and highest incoming-only channels of X.25 VC, and
its value ranges from 0 to 4095. If hic (highest incoming-only channel) is set to 0,
lic (lowest incoming-only channel) must also be set to 0, which indicates that the
incoming-only channel section is disabled.
in-channel loc hoc: Lowest and highest outgoing-only channels of X.25 VC, and
its value ranges from 0 to 4095. If hoc (highest outgoing-only channel) is set to 0,
loc (lowest outgoing-only channel) must also be set to 0, which indicates that the
outgoing-only channel section is disabled.
command to set the maximum number of VCs for
command to restore the default.