x25 response called-address
Syntax
View
Parameter
Description
Related command:
Example
x25 response calling-address
Syntax
View
Parameter
Description
x25 response called-address
undo x25 response called-address
Interface view
None
Use the
x25 response called-address
packets to carry the address information of the called DTE.
Use the
undo x25 response called-address
function.
By default, this function is disabled.
According to X.25, the call reception packet may or may not carry an address code
group, depending on the specific network requirements. This command enables
users to easily specify whether the packet carries the called DTE address.
x25 response calling-address, x25 ignore called-address, x25 ignore
calling-address.
# Specify that the call receiving packet of a call sent from the X.25 interface Serial
2/0 carries the called DTE address.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 response called-address
x25 response calling-address
undo x25 response calling-address
Interface view
None
Use the
x25 response calling-address
address information of the calling DTE in call reception packets
Use the
undo x25 response calling-address
By default, this function is disabled.
command to enable X.25 call reception
command to disable the above
command to enable X.25 to carry the
command to restore the default.
455