Ppp Mp Min-Bind - H3C MSR 20-20 Command Reference Manual

518 C 31: PPP
HAPTER AND
Description
Related command:
Example

ppp mp min-bind

Syntax
View
Parameter
Description
MP C C
ONFIGURATION OMMANDS
Use the ppp mp max-bind
links allowed in an MP bundle.
Use the
undo ppp mp max-bind
is 16.
Generally speaking, it is unnecessary to configure this argument, but in case you
need to configure it, you must do it under the guidance of technical engineers.
Such a configuration may affect the performance of PPP.
n
If MP fails to delete links, it is possibly because that the maximum number of
■
bundled links is smaller than what has actually been configured. Make sure
that the maximum binding number is larger than the actual one.
After you change the maximum number of bundled links in an MP on a
■
virtual-template or dialer interface, you must shutdown and then undo
shutdown the relevant physical interfaces before modification takes effect.
ppp mp.
# Set the maximum number of binding links to 12.
<Sysname> system-view
[Sysname] interface virtual-template 0
[Sysname-Virtual-Template0] ppp mp max-bind 12
ppp mp min-bind min-bind-num
undo ppp mp min-bind
Dialer interface view
min-bind-num: Specifies the minimum number of links in an MP bundle, in the
range 1 to 128.
Use the ppp mp min-bind
links that an MP bundle should contain.
Use the
undo ppp mp min-bind
By default, the minimum number of PPP links in an MP bundle is 0, which means
that MP dial-up relies on traffic detection.
In dial-up application, you sometimes need multiple links to bear services
simultaneously to guarantee the minimum bandwidth in transmitting a packet. In
this case, you can use this command to set the minimum links to be bound.
Note that, after you configure the ppp mp min-bind command, MP dial-up no
longer depends on traffic detection. Moreover, links that have been established
will not be removed even in case of timeout. This means that after the ppp mp
command to configure the maximum number of
command to restore the default value, which
command to configure the minimum number of PPP
command to restore the default value.