X25 Timer Tx0 - H3C MSR 20-20 Command Reference Manual

Related command:
Example

x25 timer tx0

Syntax
View
Parameter
Description
Related command:
Use the
undo x25 timer idle
By default, this value is 0.
Note that:
When a SVC stays idle (no data are transmitted) for a period specified with the
■
x25 timer idle command, the router will clear this SVC automatically.
The x25 timer idle command applies to all the SVCs under the interface. You
■
can also use the options in the x25 map command to configure the maximum
idle time for the SVC related to the address mapping and the priority is higher
than the configuration of the interface.
If the value is set to 0, this SVC will be reserved no matter how long it stays
■
idle.
Using this command does not work for PVC or the established SVC of X.25
■
switching.
x25 map.
# Set the maximum idle time of the SVC on the interface Serial 2/0 to 10 minutes.
<Sysname> system-view
[Sysname] interface serial 2/0
[Sysname-Serial2/0] x25 timer idle 10
x25 timer tx0 seconds
undo x25 timer tx0
Interface view
seconds: X.25 restart timer in seconds. It ranges 0 to 1000.
Use the
x25 timer tx0
Use the
undo x25 timer tx0
The default restart timer on the X.25 DTE is 180 seconds and that on the DCE is
60 seconds.
According to X.25, a timer should be started when the DTE sends a restart request
(or a DCE sends a restart indication). If no peer acknowledgement is received after
the timer timeout, the sending end will take some measures to guarantee the
normal proceeding of the local procedure. This parameter specifies the time of this
timer.
x25 timer tx1, x25 timer tx2, x25 timer tx3.
command to restore the default.
command to set the restart timer for DTE (or DCE).
command to restore the default.
465